What is the purpose of steaming? what is a steaming hand coffee pot?

There are two purposes of steaming:

First, in order to release the gas in the coffee particles, mainly carbon dioxide. Generally speaking, the closer it is to the baking time, the more bubbles usually occur during prepreg. On the other hand, the coffee beans with deeper roasting degree will release more gas in the steaming process than the coffee beans with lower roasting degree because of less water content.

Second, if the coffee particles after exhaust gas can be evenly absorbed and saturated, the subsequent extraction can be uniform. In short, during steaming, the air between the coffee powder particles expands and releases a large amount of carbon dioxide, while a short gap layer between the coffee powder particles will provide the space needed for hot water to pass through the powder layer during formal water injection.

If the initial step of hand flushing is less steaming, a large amount of hot water will follow a local and a small number of waterways through the powder layer, so that the dripping time will be longer, which may lead to excessive extraction, because the extraction time is longer and more substances are dissolved. the taste may be more sour and irritating, or full of miscellaneous taste. However, once you can pay attention to the action of steaming and then start formal water injection, the hot water can pass through the filter layer evenly composed of coffee powder, and then achieve the purpose of uniform extraction.

The following points will be conducive to the smooth achievement of steaming:

Before steaming with water, make sure the coffee powder is as horizontal as possible in the filter screen or filter paper.

When steaming, the force of injecting water is not too strong, gently.

The amount of water used in steaming should be 10% of the total water. For 240 milliliters of coffee, the amount of water needed for steaming is about 24 milliliters.

In the process of steaming, there is as little extract as possible; when there is too much extract in the kettle, the amount of water injected should be reduced, or attention should be paid to the degree of grinding.

The steaming time is about 30 to 60 seconds. When the expansion of the coffee powder surface is over and the surface is about to shrink, it means that the steaming is complete and the first water injection can be started. In an ideal steaming process, the coffee powder will slowly expand in the presence of hot water, as if the coffee powder keeps pushing the hot water to the top. At this time, the surface tension of the water and the pressure caused by the carbon dioxide released by the coffee powder add up to the gravitational acceleration of slightly larger water and the downward pulling force caused by capillarity. The best end time of steaming will be the sum of the surface tension of water and the pressure produced by carbon dioxide released by coffee powder when the expansion reaches the limit, which is slightly equal to the downward pulling force and stable water injection speed caused by the gravity acceleration of water and capillarity. at this time, the void layer in front of the coffee powder particles has not yet collapsed, so it is a good time to start the first water injection. Although the longer steaming time may get a thicker taste, it is also easy to affect the cooking results because of the larger surface area in contact with the air and the rapid decrease of water temperature.

Whether a cup of hand-brewed coffee has a pleasant flavor depends largely on whether a good filter layer is formed, except for the nature and freshness of the beans, while steaming will determine whether the hot water can pass evenly through the coffee powder. In Bloom is not only the prelude to coffee extraction, but also one of the key steps that can not be ignored in coffee extraction.