Which coffee cloth powder machine is easy to use the TWISTER powder dispenser with uniform distribution powder?

Professional coffee knowledge exchange more coffee bean information please follow the coffee workshop (Wechat official account cafe_style)

The correct method of filling Italian Coffee Powder Press Coffee Powder

1. Twister is only suitable for 58mm caliber filter cup. 58mm filter cup can be used regardless of the weight of several grams.

For the single-person filter cup, it is necessary to accelerate the rotation of the blade because of the low friction at the bottom of the filter cup.

IMS/9 g or 12 g conical SINGLE filter cup (thanks to Mrs. Feng for your advice)

two。 The bottom of the filter cup is almost filleted, so it will cause the blade to vacate.

The height from the bottom is about 3--5mm, but it does not affect the flavor performance of Twister whole powder.

The bottom of the filter cup is mostly fillet shape.

3. When using Twister, gently buckle the handle without shaking.

If the force is too urgent, it is easy to cause axis deviation, and the blade unilaterally friction the inner edge of the filter cup.

Too urgent, it is easy to cause deviation.

4. If the user cares that the blade will slightly grind the inner edge of the filter cup, it is recommended to use fine sandpaper

Manual way slowly grind the maximum outer circle of Twister blades to reduce the sense of friction.

Please note that the outer circle of the grinding blade may increase the residual powder on the inner and outer edge of the filter cup.

5. The residual powder at the bottom of the leaf will be due to bean grinder, temperature, humidity, stickiness of coffee beans,

Coffee powder thickness, static electricity, resulting in more or less residual powder.

This is a normal phenomenon, and the amount of residual powder can be reduced by adjusting the above factors.

6. The axis rotates against the clock because of the tolerance (error) of the outer hole of the bearing.

Or surface treatment, resulting in reversible clockwise rotation of the axis.

This condition does not affect the function of Twister normal powder distribution at all, and it is a normal phenomenon.

7. After the coffee powder is poured into the Twister, the leaves are rotated clockwise, and the leaves will turn the coffee powder.

Begin to screw down the powder, while the blade and axis will rise layer by layer.

If the long-spinning blade and the axis do not rise, it means that there is a downward force when the axis is rotated.

As a result, the leaves cannot rise. The solution is to accelerate the rotation speed, do not apply force down

After a lot of practice, you can understand the speed and mode of rotating blades.

8. If the Twister is removed, it is found that there is a hole in the middle of the coffee powder in the filter cup.

It means that there is an upward pulling axis when rotating, resulting in incomplete powder distribution in the bottom layer.

It is pulled up one layer, unable to make up the powder in the middle, forming a hole in the middle of the coffee pressed powder.

The solution is to accelerate the rotation of the axis, do not apply downward pressure, do not pull up, can reduce the generation of voids.

.