Barista skills: making Italian concentration time & grindness and Italian concentrated extraction

Time is the third most important element in the production of espresso. Here time refers to the extraction time, that is, from pressing the extraction key to pressing the stop extraction key. It also determines the success or failure of a cup of concentrate. If you use 20 grams of coffee powder to produce 50 grams of liquid, but you only use 10 seconds, then maybe this cup of concentrated will not taste very good. Now it takes between 22 and 40 seconds to extract and concentrate, and in most cases we take 25 to 32 seconds to extract and concentrate.

But now in the process of extraction, we think that the importance of liquid weight is more important than time, so we should first ensure the correct liquid weight and then pay attention to its time. For example: our ideal state is: 20g powder 40g liquid, 30 seconds. We find that the liquid weight is fixed and the time can be relaxed.

Why can time be adjusted? Because it's not very important.

There are three factors that affect the extraction time of concentration:

1. Particle size of powder

Imagine two pipes, one filled with stone and the other filled with sand. When the water flows through, the pipe filled with stone must be faster than the one filled with sand. In fact, this truth is also applicable in concentrated extraction. The resistance of fine particles to water is greater than that of coarse particles.

2. The magnitude of the pressure

The coffee machine is set to 9bar pressure, which is a pressure that can be used by most machines, and as you can imagine, the smaller the pressure, the slower the concentration. In general, the traffic is about 250-500ml/30 seconds. You can measure it-take off the handle of the coffee machine and press the extraction button, then catch the water flowing out and measure it. I found that it is optimal if the traffic is in 200-280ml/30 seconds. Even if each head on a machine has a different flow rate.

3. The difference of powder net

The difference between powder mesh is mainly in the size of the hole. This is called the "total open area" referred to as TOA. More TOA will make it easier for water to flow through the powder net, but don't worry too much, we are already using VST powder net.

So focus our most attention on the particle size of the powder, because you will spend the most time on it. Once we have locked in the liquid weight and powder weight, then we are left to determine the extraction rate by adjusting the time. Adjusting the degree of grinding will involve increasing or decreasing the strength or extraction rate at the same time. In most cases, fine grinding will increase the extraction rate and concentration. Because fine grinding is to increase the surface of the coffee that is extracted. So take a look at the following picture:

Let's consider the following example: 20g of powder produces 50g of liquid, which takes 25 seconds. After you taste it, you find it is thin and sour. It is found that there may be insufficient extraction. At this time, do not adjust the flavor by adjusting the liquid weight, because more liquid will make the concentration more water, and less liquid will make the concentration more sour. Then the mill will be fine to increase the flavor and alcohol thickness.

In practical work, if we find that the flow rate is too fast or too slow, we should learn to think about the degree of grinding. Back to the first sentence-liquid weight is more important. So let's sum up:

1. Time is flexible, and the goal is to achieve your expected liquid weight.

2. Time is fine-tuned and serves the liquid weight.

3. Although pressure, flow and powder mesh can affect the extraction time, you don't need to adjust them too often.

4. Fine = short time coarse = long time more professional coffee exchanges, please scan the code to follow Wechat: FrontStreetCoffee