Latte flower drawing teaching leaf embossing flower drawing process what kind of milk can be used to draw flowers

Today, Qianjie comes to share a new basic flower drawing pattern-"leaves"! This time, the leaf pattern is almost the same as the thousand-layer heart in the method, which is formed by regular symmetrical lines made by swinging the milk tank at the same speed. If you have learned a thousand layers of heart, then it is equivalent to the leaves are also in the bag.

What is the difference between leaves and thousand-layer hearts in production? Of course, from the result, the heart and leaves are very different graphics, so we should pay attention to the differences between the two patterns in the process of making. The first point is that the injection point of the drawing is different, to make a thousand-layer heart pull flower, the injection point is near the one side of the vat, which makes the whole figure fuller and the figure in the center. In the production of leaf flower drawing pattern, the injection point is at the central point of the liquid surface. If the injection point is the same as the thousand-layer heart, then the whole leaf pattern will be on the top.

The second point is that the leaves have a backward swing, which is the opposite of a thousand layers of heart or forward swing. It is the change of this movement that distinguishes the two distinct patterns of leaves and hearts. Leaves pull flower steps leaves and thousands of layers of heart belong to the same embossed graphics, so in the milk foam and coffee oil need a thinner state, good fluidity. For example, it is just right for 5% full milk to 6% full milk foam. First of all, it is fused to the full of 6-7 minutes of the cup volume, and then injected from the central point, like pulling a thousand-layer heart, swinging the milk tank rhythmically out of the line, at first, do not worry to move backward, fixed in the central position to swing back and forth, holding the coffee cup slowly back to the cup, let the whole figure flow back to form a package potential.

Then the right hand holding the milk jar slowly swings back at a uniform speed. When retreating, the cylinder mouth can be raised appropriately to prevent foam from piling up and forming a lump. Height control between about 0.5-1cm, too high will also wash away the white foam, forming a slender, ugly pole when almost back to the edge of the cup to start the action of ending, do not rush to raise the end to pull forward, the correct way is to lower the cylinder mouth, pour out more white foam, so that the end to form a small peach heart size and then improve the cylinder mouth forward ending. Here are some leaf-specific mistakes that are easy to occur. The first one is not wrapped up with equal embossed flow after the first picture, but retreats directly, which makes the figure top-heavy and not very beautiful.

The second is when the cylinder is swinging back, the range of the swing is getting smaller and smaller, so the lines forming a retreat can not be dispersed, very narrow, and it looks like the feet are heavy and light, not very beautiful.