Coffee review

Name resolution structure and picture introduction of coffee machine parts

Published: 2024-09-19 Author: World Gafei
Last Updated: 2024/09/19, Coffee machine 1. Change the power switch of the coffee machine to the heating gear every morning to heat the coffee machine. Make sure the power indicator is on and hang the two filter handles on the coffee faucet of the machine. 2. Pour the coffee beans into the bean bowl of the bean grinder and pour out only the amount of beans needed for that day. Repackage the remaining coffee beans and store them in a dry room temperature. 3. About fifteen minutes later

Coffee Maker

1. Turn the power switch of the coffee maker to the heating gear every morning to heat the coffee machine. Make sure the power indicator is on and hang the two filter handles on the coffee faucet of the machine.

2. Pour the coffee beans into the bean bowl of the bean grinder and pour out only the amount of beans needed for that day. Repackage the remaining coffee beans and store them in a dry room temperature.

About 15 minutes later, the pressure gauge on the coffee machine reaches the set position, indicating that the machine has been heated and ready for use.

4. in order to ensure that a high-quality coffee drink can be made, turn on the coffee switch before making coffee and release about 5 ounces of water from each of the two faucets, and some steam and hot water from the steam pipe and hot water pipe on both sides. heat the coffee machine fully for another ten minutes. 5. Turn on the power of the bean grinder to grind the coffee beans, do not grind too much powder in advance, so as to avoid the loss of coffee powder aroma.

6. Hold the filter handle in the left hand and turn to the left to remove the handle and insert the handle under the bean grinder. Pull the powder dispenser with your right hand.

7. Tap the edge of the filter with one end of the small end of the hand-held powder press to smooth the powder, and then press the powder down vertically at the end of the big head. Then tap the edge of the filter with one end of the small head and press the powder firmly with the big end for the second time.

8. Wipe off the residual powder on the edge of the filter by hand, turn on the coffee switch and release hot water for 3 seconds, then hang the hand on the machine faucet and turn right and lock it.

9. Take the coffee cup from the warm cup board on the upper part of the machine and put it under the outlet of the faucet. Press the corresponding coffee button on the lower board.

10. After the coffee is done, turn the hand to knock the coffee grounds into the dregs bucket, wipe the filter net with a brush or a clean cloth, and gently buckle the handle to the faucet to preheat and keep warm.

0