There is always a triangular warning sign on the coffee machine control panel that the beans cannot be ground.

There is always a triangular warning sign on the coffee machine control panel that the beans cannot be ground.

To prevent knotting and tripping caused by the power cord, you can choose a short power cord or a detachable power supply. b. Long wires or multiple plug-ins should be used to ensure safety. c. If you use a long line or more than one plug-in board, 1. The voltage after extension should meet the requirements of the machine. two。 If there is a ground wire, the Jack should be connected in a three-hole way and grounded as required. 3. When using a long cable, care should be taken to prevent the power cord from pulling down the machine. This coffee machine is suitable for cooking Italian espresso, which can be cooked with coffee beans or ground coffee powder. At the same time, this machine can produce hot water and steam. This machine was originally designed for family use and is not suitable for large-scale fields such as companies and coffee shops. Note that damage caused by the following actions will not be warranted: unauthorized plugs that are not used for design purposes and not sent to an authorized service center for repair, failure to remove dirt from power cord machine components, and the use of non-original components and accessories below 0 ℃, the warranty will be deemed invalid. 1.1 for your cursory reading, the "triangle warning sign" indicates the matters that should be paid attention to in order to ensure the safety of the user. Illustrations, components or control keys have been marked with numbers or letters. Please refer to the schematic diagram on page 3. The square sign is to show how best to use the machine. The actions mentioned in the text can be performed with reference to the schematic diagram on page 3

One. when the coffee machine cannot be turned on, the reason may be that the power is not turned on, the coffee machine is on standby, or the power plug is not plugged in. The solutions are as follows: 1. Turn on the power switch .2. Reseat the power plug. 3. Press the coffee button to restart the machine.

Two. when the coffee is not hot, the reason is that the coffee cup is too cold. The solution is to warm the coffee cup.

Three. Hot water or steam cannot be exported because the output pipe is blocked. Solution: turn on the output tube with a needle.

Fourth, coffee CREMA is too little, because the coffee beans are not freshly roasted or improperly mixed. The solution changes the mix.

Five. the heating time of the machine is too long and the flow rate of hot water output is very small, the reason is that there is too much scale inside the coffee machine. The solution is given to the machine for scale removal.

Six. The coffee maker brewer cannot be removed because the brewer is not in the initial position or the dregs tank has not been removed. The solution: 1. Put all the accessories in place and open the machine, and the brewer will automatically return to its original position. two。 Take out the bean dregs tank before taking out the brewing machine.

Seven. the bean grinder works but does not export coffee for the following reasons: 1. The water tank is short of water, the brewer is blocked, the pipeline in the machine is not filled, the machine is automatically adjusting the amount of powder, hot water and steam knobs are not in the correct position. The solutions are as follows: 1. Add water and fill the inner line of the machine. two。 Clean the brewer. 3. Filling machine internal pipeline 4. Make some coffee. 5. Adjust the knob.