Coffee review

How to get the extraction part of Delong coffee machine S3200 stuck at the bottom?

Published: 2024-11-03 Author: World Gafei
Last Updated: 2024/11/03, Delong coffee machine S3200 extraction part stuck in the bottom how to go up 1 Delong 2200, Delong 3000B, Delong 3200, Delong 4000, Delong 4200 series coffee machine, the warning light is always on and the machine does not work. After entering the test mode, start the motor, the motor has a slight action, but does not work. After inspection, the bridge stack (rectifier bridge) on the circuit board is damaged and the bridge pile is replaced.

How to get the extraction part of Delong coffee machine S3200 stuck at the bottom?

1 Delong 2200, Delong 3000B, Delong 3200, Delong 4000, Delong 4200 series coffee machine after startup, the warning light is always on, the machine does not work.

After entering the test mode, start the motor, the motor has a slight action, but does not work. After inspection, the bridge stack on the circuit board (rectifier bridge) is damaged, replace the bridge stack, troubleshooting.

2 ESAM2200, ESAm3000B, esam3200S, esam4000B, esam4200 series coffee machine, fault: the amount of coffee can not be adjusted, the water shortage lamp flashes, but it can make coffee, after putting hot water, the water shortage light is not on, but after making a cup of coffee, the water shortage lamp flashes again.

The water meter is broken

3 release steam, no steam, later, the water shortage indicator flashes.

There may be something wrong with the pump

4 if the automaton bean grinder has finished grinding, the water pump starts to work to make coffee and suddenly removes the water tank, what will happen, what accessories will break down, and how to deal with it.

The water tank should be put back and hot water should be released.

The thermal protector of the heater is easy to damage.

5. Delong 3500, Delong 6600, after boot, there is no Ready message for a long time, and finally there is GENERICALARM.

Check if there is heat in the warm cup area.

Usually the heater doesn't work, check the temperature protector.

6 as the customer did not completely shut down the case, the extractor will be forcibly pulled out, and forced installation, but the water plate is not in place, how to solve the fault without dismantling the machine?

Unplug the power supply

Manually reset the coffee grounds and door switch

Switch (the power) on

Automatic reset of extractor

0