Delong esam4000 extractor does not reset the use of instructions difference

Difference in operating instructions for non-reset of Delon esam4000 extractor

1 Delong 2200, Delong 3000B, Delong 3200, Delong 4000, Delong 4200 series coffee machine after startup, the warning light is always on, the machine does not work.

After entering the test mode, start the motor, the motor has a slight action, but does not work. After inspection, the bridge stack on the circuit board (rectifier bridge) is damaged, replace the bridge stack, troubleshooting.

2 ESAM2200, ESAm3000B, esam3200S, esam4000B, esam4200 series coffee machine, fault: the amount of coffee can not be adjusted, the water shortage lamp flashes, but it can make coffee, after putting hot water, the water shortage light is not on, but after making a cup of coffee, the water shortage lamp flashes again.

The water meter is broken

3 release steam, no steam, later, the water shortage indicator flashes.

There may be something wrong with the pump

4 if the automaton bean grinder has finished grinding, the water pump starts to work to make coffee and suddenly removes the water tank, what will happen, what accessories will break down, and how to deal with it.

The water tank should be put back and hot water should be released.

The thermal protector of the heater is easy to damage.

5. Delong 3500, Delong 6600, after boot, there is no Ready message for a long time, and finally there is GENERICALARM.

Check if there is heat in the warm cup area.

Usually the heater doesn't work, check the temperature protector.

6 as the customer did not completely shut down the case, the extractor will be forcibly pulled out, and forced installation, but the water plate is not in place, how to solve the fault without dismantling the machine?

One. First check whether the water in the tank is full, and then connect the power connector to the power supply.

Move the milk foam generator to the outside of the machine and place a container under it then press the control panel power to turn on the key.

Three. after the above work is done, after up to 30 seconds, rotate the assembly "B" steam gear knob counterclockwise until it is screwed to the head.

Four. After a few seconds, some water will flow out of the milk foam generator. When approximately 30cc water has flowed, rotate the steam gear knob clockwise so that there will be no more water flow when it cannot be screwed.

5. Control panel single cup coffee temperature ok indicator or double cup coffee temperature ok indicator is no longer flashing, but is in a state of solid light.

Six. before the light stops blinking, the coffee will automatically run a cleaning cycle, when a small amount of hot water will flow out of the "|" coffee mouth and directly into the "G" drip tray.