Coffee review

Delonghi coffee machine extractor

Published: 2024-06-03 Author: World Gafei
Last Updated: 2024/06/03, Delonghi Coffee Machine take out extractor 1 Delon 3000 Coffee Machine after turning on, the warning light is always on and the machine does not work. After entering the test mode, start the motor, the motor has a slight action, but does not work. After inspection, the bridge stack on the circuit board (rectifier bridge) is damaged, replace the bridge stack, troubleshooting. 2 Delong coffee machine 3000, 4000 series, fault: coffee water quantity

Delonghi coffee machine extractor

The warning light is always on and the machine does not work after the Delon 3000 gamble 4000 series coffee machine is turned on.

After entering the test mode, start the motor, the motor has a slight action, but does not work. After inspection, the bridge stack on the circuit board (rectifier bridge) is damaged, replace the bridge stack, troubleshooting.

2 Delong coffee machine 3000, 4000 series, fault: the amount of coffee can not be adjusted, the water shortage lamp flashes, but it can make coffee, after putting hot water, the water shortage light is not on, but after making a cup of coffee, the water shortage lamp flashes again.

The water meter is broken

3 release steam, no steam, later, the water shortage indicator flashes.

There may be something wrong with the pump

4 if the automaton bean grinder has finished grinding, the water pump starts to work to make coffee and suddenly removes the water tank, what will happen, what accessories will break down, and how to deal with it.

The water tank should be put back and hot water should be released.

The thermal protector of the heater is easy to damage.

5 Delong coffee machine 3500 6600, after being turned on, there is no Ready message for a long time, and finally GENERICALARM appears.

Check if there is heat in the warm cup area.

Usually the heater doesn't work, check the temperature protector.

6 as the customer did not completely shut down the case, the extractor will be forcibly pulled out, and forced installation, but the water plate is not in place, how to solve the fault without dismantling the machine?

Unplug the power supply

Manually reset the coffee grounds and door switch

Switch (the power) on

Automatic reset of extractor

0