[notes of the baristas in front of the street] how did the "one-size-fits-all" swans get trained?

Today, the editor's little sister pulled a beautiful ❤ swan ❤, so the editor can't wait to write a [Little Swan] flower drawing tutorial for everyone.

Of course, a good-looking [Little Swan] flower must be paired with delicious espresso to make a perfect latte, don't you think?

The beans of espresso used by the editor are [front street boutique mix], and the ratio of Brazil to Colombia is 6:4.

Pull a [Little Swan] time is only about 10 seconds, the little sister or slow down the speed, does it feel fast? Haven't you seen it yet?

It doesn't matter, the editor has prepared the GIF of the decomposition steps.

The first step

Mix espresso and milk well

Step two

When you start to make embossed flowers like leaves, you should pay attention to controlling the flow rate. If the milk tank swings more times, the lines of the wings will be finer, like a thousand-layer heart; when the milk tank swings less, the lines will be clearer. In addition, it should be noted that we usually pull leaves in a straight line, but tilt slightly toward the edge when pulling [Little Swan] wings.

Step three

Raise the milk tank a little bit, control the flow more carefully, push to the left (not from the middle axis of the leaf, but to the left along the break point of the leaf on the inside) stop at about one-third of the leaf. This is to lower the milk tank and increase the flow of water to prepare the neck for the next step.

The fourth step

The neck should be pulled back to the right. At this time, we should pay attention to the process of the neck from thick to thin, so we should pay attention to the excessive flow from thick to thin. Because the neck of the [Little Swan] is relatively long, it begins to construct near one-third of the wing, feeling like a "?" .

Step five

After the neck is done, it will be the head of the Little Swan, which is relatively simple, that is, it will be finished with a small solid.

The editor thinks that when pulling the Little Swan, there are a few points to pay attention to:

① milk and foam should be fully mixed, because the editor has tried to pour the small solid when the milk and foam are layered, poured out is all foam, pull out the small solid will not look good.

② should not flow too much and too fast when doing the second step, otherwise the wings will be easily deformed.

③ wings are taller than the neck to look good.

I hope this little tutorial can help you all.

Finally, the editor attached links to other tutorials of flower drawing.