How to make milk foam without milk foam pot-Beginners to make milk foam video tutorial

How to foam without a bubble pot-video tutorial for beginners

There are many ways of foaming milk on the market, but it can be roughly divided into two categories: one is the combination of milk and milk foam, and the other is to separate the stages of milk foam and milk foam. that is, first beat the milk and then beat the milk foam. The milk bubble tissue formed by these two ways is different from the taste. In the first way, the milk bubble tissue will be more delicate and soft, but the silk degree of the milk bubble will be thinner, and it is not easy to produce dense and elastic milk bubble tissue, but the pattern of pulling flowers is easier to form. The second way is to beat the milk first and then beat the milk foam tissue with a high degree of silk, which can produce QQ elastic milk bubbles, but it is easier in the passing stage, and it will be more difficult to make the pattern of pull flowers, but the basic principle of making coffee flowers taste denser than milk foam is to use steam to beat milk, so that liquid milk into the air, making use of the surface tension of milk protein. Form a lot of small foam, let the liquid milk volume expand, become the foam-like milk bubble. In the process of foaming, lactose dissolves in milk because of rising temperature, and uses foaming to seal lactose in milk, while the function of milk fat is to make these small foams form a stable state, so that when these milk bubbles are drunk, the fine foam will burst in the mouth, so that the taste and aromatic substances have a better magnifying effect, so that the milk produces a sweet and thick taste and taste. Moreover, when it is fused with coffee, the adhesion between molecules will be relatively strong, so that the full combination of coffee and milk, so that the special properties of coffee and milk are highlighted respectively, and completely fused together to complement each other.

The lower the starting temperature of the foam, the longer it can be operated, and of course, the more delicate it can be, which is one of the reasons why milk needs to be refrigerated. Milk foam is usually the best to do flower drawing when heated to more than 60 degrees. But we use a manual milking machine. The heat will be lost. Heat it to about 70 degrees (don't go any higher, the foam will get thicker if you get higher). The end temperature of the milk is fixed (do not exceed 65 degrees).

The amount of milk

The amount of milk added is about 2 pound 5 is enough, do not hit the highest when milking, keep the speed of the state to hit more than ten times is enough, more and more will be more and more dry. Then use a spoon to scrape off the upper layer of about 2-3cm of coarse milk foam and pull it against the flower cup several times. After pulling, tap a few times on the table, then foam in the cup, shaking the cup clockwise or counterclockwise until it is poured into the coffee. Because once you stop, it will be divided into upper and lower levels. The common problem of hand-beating milk foam is that it is relatively dry, and milk and foam are separated. It is said that the double-layer milking effect will be finer but drier than the single-layer milking effect. It has not been verified.