How to make coffee foam-how to make a good coffee bubble video
How to make coffee foam-how to make a good coffee bubble video
The first step: first do fast low hit, hit until there is obvious resistance and continuous feeling; then do medium hit, also hit obvious resistance and continuous feeling; finally do high hit, hit as a whole have resistance and continuous feeling. Tip: pay attention to the height of the twitch.
Step 2: repeat the first step. In this way, the process of manual milking is completed. If you want your foam not to be too thick, to have a certain sense of flow, just take the first step. Pulling out the piston vertically after foam is helpful to drive out a lot of coarse bubbles. (since the picture has not been downloaded, we do not know the specific samples of the author's low, medium and high hits.)
Production of hand-made hot milk foam
Heat the milk (milk that can be foamed and held, recommended Nestle) to a temperature that is hot (60 to 70 degrees) but can be held. What kind of heating method is used is not important, the key is to reach this temperature (why this temperature should be reached will be discussed later). The heating method used in the store that I have instructed is the microwave oven. at first, it is slowly trying to find out how long it takes to heat the milk to the target temperature with a big fire, and then just put the milk in and heat it at the time after the test. it's very convenient and very fast.
1. Does milking have a lot to do with the steam pressure of the machine? The foam produced by single-hole steam is not dense enough. Is it related to pressure? How should the angle be controlled?
2. Is it true that the milk bubbles made by heating the milk and then using the milk bubble jar can not be used to pull flowers? Is it only suitable for carving?
3. Is it necessary to beat all the milk into foam when the milk is delaminated with the milk foam? The milk foam floats on the milk, and when you pour the coffee, how can you make the milk foam melt into the coffee together with the milk?
4. Is coffee with little oil, or coffee that can't be seen soon after extraction, not suitable for flower drawing?
- Prev
How do you beat the foam?-what do you want to do with the foam by hand?
How to beat the foam-what do you want to hit by hand? one is the temperature at which the foam starts and ends, and the other is the temperature at which the foam is made. These two temperatures are very important for beginners, which is directly related to the mastery of the principle of foam. Let's start with foaming. Milk is cold at first (preferably refrigerated at 5 ℃), which can prolong the foaming time and make it foamy.
- Next
Coffee froth beating skills-hand beating milk foam skills video tutorial
Milk temperature milk temperature is a very important factor when milk temperature rises by 2 degrees Celsius, the shelf life of milk will be reduced by half, and the higher the temperature is, the more milk fat breaks down, the lower the degree of foaming. When stored at the same storage temperature, the longer the storage time, the more milk fat decomposes.
Related
- What is the meaning of lactic acid fermentation with coffee bean treatment?
- How to judge the state of foam by sound?
- How does the latte pull out the unicorn pattern? Come to get for a little trick to improve the flower pull!
- Will flower pulling affect the taste of the latte?
- Do you know the history of coffee?
- The difference between honey treatment and sun washing what is raisin honey treatment?
- What kind of milk can a novice use to make coffee foam to keep the foam longer? The correct method and skills of milking tutorial sharing
- Why do washed coffee beans taste sour? Flavor characteristics of washed Coffee
- Introduction to the skill of how to practice the size and height of water injection around the circle of hand-brewed coffee
- How do beginners practice coffee flower drawing from scratch?