How do you beat the foam?-what do you want to do with the foam by hand?

How do you beat the foam?-what do you want to do with the foam by hand?

One is the starting and ending temperature of foaming, and the other is the temperature at which the milk foam is made. These two temperatures are very important for beginners, which is directly related to the mastery of the principle of foam. First of all, when it comes to foaming, the milk is cold at first (preferably refrigerated at 5 ℃), which can prolong the foaming time so that it can be fully foamed and delicate, and then open the steam valve to foam the milk. When foaming is consistent with our body temperature (feel neither hot nor cold), the foaming is cut off. Next, let's talk about the temperature at the end of milking. I just want to talk about what the temperature feels like on the hand. When we feel this temperature with our hands (in continuous heating), it is hot, but we can stand it for two or three seconds; as soon as we feel warm, we stop heating (the back end of the heating feels very hot on the hand, but it can hold it).

In some places, thermometers are used to measure. I think this kind of teaching method is not good. Technology is something that people need to understand attentively, and it is not very good for people to improve their own skills with the help of external forces. Xiaohan thinks that scientific metrology is also good, so it is very difficult for traditional Chinese medicine to pass on.

Heat the milk (milk that can be foamed and held, recommended Nestle) to a temperature that is hot (60 to 70 degrees) but can be held. What kind of heating method is used is not important, the key is to reach this temperature (why this temperature should be reached will be discussed later). The heating method used in the store I have instructed is the microwave oven. at first, it is slowly trying to find out how long it takes to heat the milk to the target temperature with a big fire, and then just put the milk in and heat it at the time after the test. it's very convenient and very fast.

The amount of milk added is about 2 pound 5 is enough, do not hit the highest when milking, keep the speed of the state to hit more than ten times is enough, more and more will be more and more dry. Then use a spoon to scrape off the upper layer of about 2-3cm of coarse milk foam and pull it against the flower cup several times. After pulling, tap a few times on the table, then foam in the cup, shaking the cup clockwise or counterclockwise until it is poured into the coffee. Because once you stop, it will be divided into upper and lower levels. The common problem of hand-beating milk foam is that it is relatively dry, and milk and foam are separated. It is said that the double-layer milking effect will be finer but drier than the single-layer milking effect. Unverified)