Coffee review

The heart-shaped pull of coffee flowers

Published: 2024-11-02 Author: World Gafei
Last Updated: 2024/11/02, 1: after selecting the injection point to shake the milk foam up and down and shaking from left to right, the straight line extending downward from the mouth of the cup is perpendicular to the straight line extending forward by the handle of the coffee cup, and the injection point is selected at 3 points of the diameter of the cup mouth. 2: quickly pierce the injection, keep the small flow rate vertical and control the velocity of espress grease layer, at this time, the loop method / left and right moving method can be carried out.

1: select the injection point

After the milk foam is shaken up and down and shaken left and right fully, the straight line extending downward from the mouth of the cup is perpendicular to the straight line extending forward by the handle of the coffee cup, and the injection is selected at 1 stroke 3 of the diameter of the cup mouth.

2: piercing quickly

When injecting, keep the small flow vertical and control the velocity of espress grease layer, at this time, the "loop method" / "left and right moving method" can be used for small flow fusion.

3: look at the whitening point

Fusion is a process of stability and repair, which can be understood as a method in the early days of "America". The amount of fusion can be selected according to the pattern created, but pay attention to the whitening points caused by the foam in the process.

4: increase traffic

After the whitening point appears, it is necessary to increase the injection flow rate and maintain, the foam flows out of a certain Radian from the cylinder mouth, and carries on the free 1cm distance, swings evenly, and the frequency speed leads to the effect of layers and lines.

5: pattern formation

With the flow and swing, the heart-shaped pattern is gradually taking shape, in this key process, do not move the pull cylinder "back" when swinging. This will cause the pattern to become "leaf" or "long heart".

6: straight line endings

Whether it is the heart shape created by segmented injection or the heart shape produced by delicate embossing, when it comes to the completion of the pattern creation, it is necessary to increase the small flow of the drawing cylinder, just like the vertical injection, ending in a straight line.

0