Introduction to the flavor description of the video tutorial of coffee drawing and milking skills

Introduction to the flavor description of the video tutorial of coffee drawing and milking skills

Cold milk foam is the milk foam produced by pouring fully refrigerated milk directly into a manual milking machine and using a manual milking machine. This kind of milk foam is widely used on iced coffee and has a good effect. However, the author occasionally adds it to hot coffee and obtains the different performance of cold and hot effects in a cup of coffee, which is worth a try.

The temperature of milking

The lower the starting temperature of the foam, the longer it can be operated, and of course, the more delicate it can be, which is one of the reasons why milk needs to be refrigerated. Milk foam is usually the best to do flower drawing when heated to more than 60 degrees. But we use a manual milking machine. The heat will be lost. Heat it to about 70 degrees (don't go any higher, the foam will get thicker if you get higher). The end temperature of the milk is fixed (do not exceed 65 degrees).

The amount of milk

The amount of milk added is about 2 pound 5 is enough, do not hit the highest when milking, keep the speed of the state to hit more than ten times is enough, more and more will be more and more dry. Then use a spoon to scrape off the upper layer of about 2-3cm of coarse milk foam and pull it against the flower cup several times. After pulling, tap a few times on the table, then foam in the cup, shaking the cup clockwise or counterclockwise until it is poured into the coffee. Because once you stop, it will be divided into upper and lower levels. The common problem of hand-beating milk foam is that it is relatively dry, and milk and foam are separated. It is said that the double-layer milking effect will be finer but drier than the single-layer milking effect. Unverified) one is the starting and ending temperature of foaming, and the other is the temperature at which the milk foam is made. These two temperatures are very important for beginners, which is directly related to the mastery of the principle of foam. First of all, when it comes to foaming, the milk is cold at first (preferably refrigerated at 5 ℃), which can prolong the foaming time so that it can be fully foamed and delicate, and then open the steam valve to foam the milk. When foaming is consistent with our body temperature (feel neither hot nor cold), the foaming is cut off. Next, let's talk about the temperature at the end of milking. I just want to talk about what the temperature feels like on the hand. When we feel this temperature with our hands (in continuous heating), it is hot, but we can stand it for two or three seconds; as soon as we feel warm, we stop heating (the back end of the heating feels very hot on the hand, but it can hold it).

In some places, thermometers are used to measure. I think this kind of teaching method is not good. Technology is something that people need to understand attentively, and it is not very good for people to improve their own skills with the help of external forces. Xiaohan thinks that scientific metrology is also good, so it is very difficult for traditional Chinese medicine to pass on.