How to inject water into the hanging-ear coffee? How to increase the concentration of hanging ear bag the best powder-water ratio of hanging ear coffee

Professional coffee knowledge exchange more coffee bean information please follow the coffee workshop (Wechat official account cafe_style)

Summarize several common misunderstandings of hanging-ear coffee and attach tips for correctly brewing hanging-ear bags.

When steaming is done, 60% of a cup of delicious boutique coffee is done. at this time, even if you don't pay special attention to rinsing happily with hot water, the flavor will not be too bad, but the concentration is easy to be too light and the taste is not so good.

Therefore, in the process of brewing, the frequency of water injection, water cut-off, water injection and water cut-off is staggered until it reaches a sufficient dose, the concentration of the earbag can be increased, and the flavor can be completely presented.

Although it will take a little longer, it will be worthwhile to spend an extra two minutes to get a cup of delicious and fragrant coffee.

Happiness needs to take two more steps (heart), let us continue to read, the following is a continuous picture!

First water injection: with the smallest flow, inject into the center of the steaming arch, and then soak all the coffee powder evenly around the concentric circle from the inside to the outside. if the most edge is difficult to wash, it's okay to ignore it.

The coffee dripping with water for the first time will drop faster, so when the water is added to about half of the ear bag, you can stop the water first, and then hang the horizontal line of the ear bag. When you see the coffee powder, you are ready for a second water injection.

Second water injection: as can be seen from the picture, there will be an obvious depression in the middle, which is a very normal phenomenon, but do not wait for all the water to leak, and start the second water injection when there is still a little water.

This time the coffee drips a little slower and contains a little bit of water that hasn't dripped before, so this time the water injection can be a little more, making the water level a little higher than the first time.

The way of water injection is the same as the first water injection, try to keep the fine flow, but also do not have to be too nervous, flush steadily.

Third water injection: as can be seen from the picture, the depression in the second picture is not so obvious, and the coffee powder has a bright texture of full water, so the coffee drips more slowly, and you can start the third water injection when you see the coffee powder.

Because the dripping speed is slower, the concentric circle will feel underwater when injecting water, but it doesn't matter. Keep injecting water to a level of 4 to 5, and gravity will speed up the dripping of coffee.

Will the water stop for a little longer this time, or wait until the coffee is almost dripping, ready for the last injection?

Fourth water injection: the last time you inject water, you can find that the color of the top coffee foam (crema) has become very white, indicating that the flavor of the coffee has been extracted, and you are ready to finish the work.

This time, the water is still injected to the level of 4thumb. 5, let gravity squeeze and extract the essence of the coffee powder.

Of course, the taste of the coffee extracted later is lighter, but the concentration of the first half is quite high, so the effect of uniform fusion of the front and back segments is moderate concentration and uniform flavor.

Finally, after most of the coffee is dripped into the cup (150 c.c-200 c. C), the earbag can be taken out. Finally, after the coffee in the cup is slightly stirred, a cup of fine coffee with the combination of aroma, flavor and concentration will be baked.

.