Coffee review

Common failure of Xi Ke Coffee Machine-press take out instructions

Published: 2024-11-03 Author: World Gafei
Last Updated: 2024/11/03, Common failures of the Hicker Coffee Machine-press removal instructions or other machines that use steam or piston as pressure have only one boiler: the bottom of the boiler is hot water for brewing coffee, and the top provides steam, but in order to produce steam, the whole boiler must be heated to boiling, causing hot water close to the boiling point to burn coffee powder, losing the aromatic oil hidden in the coffee powder.

Common failure of Xi Ke Coffee Machine-press take out instructions

Or other machines that use steam or pistons as pressure have only one boiler: hot water for brewing coffee at the bottom and steam at the top, but in order to produce steam, the whole boiler must be heated to boiling, causing hot water near the boiling point to burn the coffee powder, losing the aromatic oil hidden in the coffee powder, and extracting doubly bitter coffee.

Because the water for brewing coffee is heated in a large boiler, the water will not be fresh if it is placed in the boiler for too long, and the temperature difference of hot water will increase due to the use of steam, because the different amount of steam also increases the temperature difference of hot water for brewing coffee.

In order to improve the temperature difference, Ernesto Valente in 1960, the world's first pump as a source of pressure FAEMA

In E61, the heating method of the water used to brew coffee has been changed, so that the water of brewing coffee does not come into direct contact with the heat source, but uses a method similar to water-separated heating.

One. when the coffee machine cannot be turned on, the reason may be that the power is not turned on, the coffee machine is on standby, or the power plug is not plugged in. The solutions are as follows: 1. Turn on the power switch .2. Reseat the power plug. 3. Press the coffee button to restart the machine.

Two. when the coffee is not hot, the reason is that the coffee cup is too cold. The solution is to warm the coffee cup.

Three. Hot water or steam cannot be exported because the output pipe is blocked. Solution: turn on the output tube with a needle.

Fourth, coffee CREMA is too little, because the coffee beans are not freshly roasted or improperly mixed. The solution changes the mix.

Five. the heating time of the machine is too long and the flow rate of hot water output is very small, the reason is that there is too much scale inside the coffee machine. The solution is given to the machine for scale removal.

Six. The coffee maker brewer cannot be removed because the brewer is not in the initial position or the dregs tank has not been removed. The solution: 1. Put all the accessories in place and open the machine, and the brewer will automatically return to its original position. two。 Take out the bean dregs tank before taking out the brewing machine.

Seven. the bean grinder works but does not export coffee for the following reasons: 1. The water tank is short of water, the brewer is blocked, the pipeline in the machine is not filled, the machine is automatically adjusting the amount of powder, hot water and steam knobs are not in the correct position. The solutions are as follows: 1. Add water and fill the inner line of the machine. two。 Clean the brewer. 3. Filling machine internal pipeline 4. Make some coffee. 5. Adjust the knob.

Eight. the reason for the weak output of coffee is that the machine is automatically adjusting the amount of powder: make a few cups of coffee.

Nine. The reason for the slow output of coffee is that the grinding is too fine. The solution is to adjust the bean grinder reason 2. Solution to the shortage of water inside the machine: fill the internal pipeline of the machine. Reason 3. The solution to the blockage of the brewer: clean the brewer.

Ten. The reason why the coffee export cannot export coffee normally is that the coffee export is blocked. The solution is clean coffee export.

Eleventh. The coffee making process cannot be carried out because the bean trough lid is not covered properly. Solution: cover the bean trough correctly and press the coffee button again.

0