Coffee review

There is always a triangular warning sign on the coffee machine control panel that the beans cannot be ground.

Published: 2024-11-09 Author: World Gafei
Last Updated: 2024/11/09, There is always a triangular warning sign on the coffee maker control panel that cannot grind beans. When the coffee machine cannot be turned on, the reason may be that the power is not turned on, the coffee machine is on standby, or the power plug is not plugged in. The solutions are as follows: 1. Turn on the power switch .2. Reseat the power plug. 3. Press the coffee button to restart the machine. Two. when making coffee is not hot

There is always a triangular warning sign on the coffee machine control panel that the beans cannot be ground.

One. when the coffee machine cannot be turned on, the reason may be that the power is not turned on, the coffee machine is on standby, or the power plug is not plugged in. The solutions are as follows: 1. Turn on the power switch .2. Reseat the power plug. 3. Press the coffee button to restart the machine.

Two. when the coffee is not hot, the reason is that the coffee cup is too cold. The solution is to warm the coffee cup.

Three. Hot water or steam cannot be exported because the output pipe is blocked. Solution: turn on the output tube with a needle.

Fourth, coffee CREMA is too little, because the coffee beans are not freshly roasted or improperly mixed. The solution changes the mix.

Five. the heating time of the machine is too long and the flow rate of hot water output is very small, the reason is that there is too much scale inside the coffee machine. The solution is given to the machine for scale removal.

Six. The coffee maker brewer cannot be removed because the brewer is not in the initial position or the dregs tank has not been removed. The solution: 1. Put all the accessories in place and open the machine, and the brewer will automatically return to its original position. two。 Take out the bean dregs tank before taking out the brewing machine.

Seven. the bean grinder works but does not export coffee for the following reasons: 1. The water tank is short of water, the brewer is blocked, the pipeline in the machine is not filled, the machine is automatically adjusting the amount of powder, hot water and steam knobs are not in the correct position. The solutions are as follows: 1. Add water and fill the inner line of the machine. two。 Clean the brewer. 3. Filling machine internal pipeline 4. Make some coffee. 5. Adjust the knob.

There is a flying knife blade at the bottom, this position is used to hold coffee beans or coffee powder, the front mouth is a half-moon-shaped warehouse, this design does not know what to do, during operation, first put coffee beans or powder into the grinder to close the lid, fill the water tank with appropriate amount of drinking water and close it, adjust the size and concentration of ground beans on the front panel. If it is coffee powder, as long as it is adjusted to the place with the △ triangle icon, that is, the first one above the off file, place the coffee drip pot in the box slot of the mainframe, and the water inlet at the top of the coffee pot must press against the anti-leakage valve of the extraction port, put it on top, and begin to extract coffee. After the coffee is made, remove the whole bean mill from the mainframe, remove the residual powder and filter, and clean the bean mill.

0