Will the coffee machine grind knob break if it is not adjusted at work?

Coffee machine grinding thickness knob is not working when the adjustment will be bad

I. When the coffee machine does not turn on, the reason may be that the power is not turned on, the coffee machine is in standby mode or the power plug is not plugged in properly. The solutions are: 1. Turn on the power switch. 2. Plug in the power plug again. 3. Press the coffee button to restart the machine.

II. When making coffee is not hot, the reason is that the coffee cup is too cold. The solution is to warm the coffee cup.

III. Hot water or steam cannot be exported because the outlet pipe is blocked. Solution: Use a needle to cast through the output tube.

IV. Coffee CREMA is too little because the beans are not freshly roasted or mixed incorrectly. Solutions change the mix.

v. Machine heating time is too long and hot water output flow is very small, the reason is: coffee machine its internal scale is too much. The solution is given to the machine for descaling.

vi. The brewer of the coffee machine cannot be removed because the brewer is not in the initial position or the residue tank is not removed. Solution: 1. Put all accessories in place to open the machine, the brewer will automatically return to the initial position. 2. Remove the okara tank before taking out the brewer.

VII. The grinder works but does not output coffee. The reasons are: 1. The water tank is short of water, the brewer is blocked, the pipeline in the machine is not filled, the machine is fully automatically adjusting the powder amount, and the hot water and steam knobs are not in the correct position. The solutions are as follows: 1. Add water and fill the pipeline inside the machine. 2. Clean the brewer. 3. Fill the pipe inside the machine 4. Make a few cups of coffee 5. Adjust the knob.

VIII. The reason for the weak coffee output is that the machine automatically adjusts the powder amount. Solution: Make a few cups of coffee.

IX. Coffee output is slow because the grinding is too fine. The solution is to adjust the reason for the grinder 2. The machine is short of water. Solution: Fill the internal pipeline of the machine. Cause 3. Brewer clogging Solution: Clean the brewer.

X. Coffee outlet can not output coffee normally because: coffee outlet blocked. The solution is to clean the coffee outlet.

Xi. The coffee making process could not proceed because the lid of the bean trough was not properly covered. Solution: Close the lid correctly and press the coffee button again