Does Nova Coffee Machine Water Distribution Network need to be replaced? introduction to the instruction manual

Does Nova Coffee Machine Water Distribution Network need to be replaced? introduction to the instruction manual

1. Remove the metal coffee filter from the coffee machine handle and install the blind bowl (anti-cleaning bowl) into the coffee handle. If there is no blind bowl, there must be a rubber blind pad when you buy the coffee machine, or you can put the rubber blind pad directly into the metal coffee strainer and remember the obvious bulge facing up.

two。 If you wash every day, take 1 tablespoon of cleaning powder; if not, take 2 tablespoons and put them in a blind bowl or on a rubber blind pad.

3. Do not rush to buckle the coffee machine handle, press the coffee machine brewing button, in the case of the brewing head work, use the coffee machine to clean and brush the water distribution net. The reason for this is to prevent too much fine coffee powder from entering the coffee machine during the subsequent backwashing process. Brush to the water without coffee grounds, you can turn off the brewing button.

4. Buckle the handle, press the coffee machine button, run for about 10 seconds, and then close for 10 seconds to make the detergent fully dissolve. Turn it on for 10 seconds and turn it off for 10 seconds, once; after doing it 4-5 times, turn off the coffee brewing button.

5. Remove the handle and clean, insert the coffee machine again, press the coffee maker button, run for 5 seconds, turn it off for 2 seconds, and do it repeatedly for 7-10 times to ensure full cleaning.

6. Remove the handle and brush the inner card slot of the boiled head again with a cleaning brush to avoid residual coffee grounds and cleaning powder