How to remove the scale of Hongbao capsule Coffee Machine

How to remove the scale of Hongbao capsule Coffee Machine

1. Press the green button in the "power switch" and turn the power on.

2. Slowly adjust the "vibration intensity adjustment knob" and rotate clockwise. At this time, the finishing plate connected with the "vibration bracket" begins to vibrate, touch the finishing plate with your hand, and adjust to a certain oscillation intensity by feeling.

3. Put the powdered capsule shell into the "powdered capsule shell finishing plate", about 300 tablets at a time. Put the capsule cap into the "capsule cap finishing plate", about 300 tablets at a time. The finishing plate is made of plexiglass board, on which there are many large and small funnel-shaped round holes, and the round hole diameter corresponds to the diameter of the capsule number. At this time, the shaking table plate capsule shell moves steadily back and forth, thus entering the hole of the table plate one by one.

4. After about 30 seconds, the powdered capsule shell and the capsule cap fall into the round hole with the opening facing up. If the individual opening is facing down, you can use the capsule cap to gently press down the sleeve, which can be pulled out.

5. Horizontal hand-held powder capsule shell connecting plate (drawn at the end of the picture, ready at random, with round holes in the connecting plate), in the whole

The lower part of the plate is gently pushed in, and the powder capsule shell in the finishing plate will fall down into the round hole of the connecting plate, and then take out the connecting plate. In the same way, use the capsule cap plate to remove the capsule cap.

6. A powder square plate with a bottom area of 500 × 500mm and a height of about 10mm on four sides can be prepared in advance, and the powder capsule shell connecting plate can be placed flat in the powder square plate. Then cover the random plexiglass frame on the powder capsule connecting plate, use a small bucket shovel powder into the frame, scrape with the edge of the frame, you can fill the powder and scrape off the excess powder.

7. Use the random capsule cap cover plate (shown at the end of the picture, there is a round hole on the set plate), put it on the capsule cap plate, with a counterhole, it is easy to place. Flip the capsule cap connecting plate so that the capsule opening is facing down, and it is placed on the powdered capsule shell connecting plate which has been filled with powder, and there is also a counter hole, which is easy to close.

8. Put the covered capsule board into the cavity under the "capsule wearing hat forming plate", pull the "pressure bar" downward with your hand and put it in place, there is no need to be careful to force too much, because there is a positioning mechanism to control the pressure height. Take out the capsule plate, pour out the capsule, and finish filling. You can cycle the next board.

1. When the brewing is finished, open the handle, and the coffee bag will automatically fall into the dustbin, clean up the leftover water in the water box and the rest of the capsule in the garbage box, and then put it back in place.

two。 Clean the water tank to make sure it dries before the next use.

3. Make sure there are no capsules in the brewing room to avoid corroding the coffee machine.

4. If you do not use the coffee machine for a long time, please wipe it clean and put it back in the box.