Nova coffee machine cleaning head structure Chinese instructions for washing head cleaning

Nova coffee machine cleaning head structure Chinese instructions for washing head cleaning

The cleaning of the coffee residue from the brewing head can separate the filter net and the copper block on the brewing head. The filter net is the part that comes into direct contact with the coffee powder every time the coffee is brewed. Because the coffee powder is pressed, the coffee liquid will flow out of the powder bowl only when it is pressed to a certain extent, so the coffee liquid may flow back before it seeps out, and some coffee residues may still be in the filter. If it is not cleaned for a long time, it may affect the taste of the coffee and it is also very unhygienic. After cleaning the copper, you can release water, because after backflushing, you may leave some powder in the pipe of the coffee machine, which is edible, but it is better to put it clean.

The last step is to bubble all the parts that can be removed in the powder solution, including filter net, copper block, handle, powder bowl, steam pipe head, and so on. The second is the cleaning of the sink, which can be cleaned with clean water or with a special detergent.

1. Remove the metal coffee filter from the coffee machine handle and install the blind bowl (anti-cleaning bowl) into the coffee handle. If there is no blind bowl, there must be a rubber blind pad when you buy the coffee machine, or you can put the rubber blind pad directly into the metal coffee strainer. If you wash every day, take 1 tablespoon of cleaning powder; if not, take 2 tablespoons and put them in a blind bowl or on a rubber blind pad.

3. Do not rush to buckle the coffee machine handle, press the coffee machine brewing button, in the case of the brewing head work, use the coffee machine to clean and brush the water distribution net. The reason for this is to prevent too much fine coffee powder from entering the coffee machine during the subsequent backwashing process. If you brush to the water without coffee grounds, you can turn off the brewing button.

4. Buckle the handle, press the coffee machine button, run for about 10 seconds, and then close for 10 seconds to make the detergent fully dissolve. Turn it on for 10 seconds and turn it off for 10 seconds, once; after doing it 4-5 times, turn off the coffee brewing button.

5. Remove the handle and clean, insert the coffee machine again, press the coffee maker button, run for 5 seconds, turn it off for 2 seconds, and do it repeatedly for 7-10 times to ensure full cleaning.

6. Remove the handle and brush the inner card slot of the boiled head again with a cleaning brush to avoid residual coffee grounds and cleaning powder.