What about the air leakage of the safety valve of the mocha kettle? what is the cause of the fault maintenance method?

What about the air leakage of the safety valve of the mocha kettle? what is the cause of the fault maintenance method?

The principle of the mocha pot is similar to that of the pressure cooker, and the most dangerous thing is the failure of the pressure relief valve of the mocha kettle; so first, we should choose a mocha pot of better quality, especially depending on the quality of the safety valve, and second, we should pay attention to the safe operation and use. There are about 200 million mocha pots in the world. The explosion of the mocha pot is actually a small probability event. There may be more incidents of siphon coffee pot breaking, but the pressure of the mocha pot explosion involves pressure, which may be frightening. But the pressure of the mocha pot is only slightly higher than the atmospheric pressure at most. Although the power of the explosion is very different from that of the pressure cooker, the possibility of hurting people cannot be ruled out. The explosion of the mocha pot is basically completely avoidable under the correct use of the mocha kettle; there is no necessity of the mocha pot explosion, only those who operate it improperly.

We should feel lucky when we see the small hole breathing. Because it shows that the mocha pot in front of you is a mocha pot of high quality. The small hole that will steam we generally call the pressure relief valve is a safety device, it can steam means that its function is normal, it can discharge too much pressure from the pot for you, so as to avoid the danger of explosion of the mocha kettle. Generally speaking, the pressure relief valve can be regarded as a standby role, but it may occur in the following two situations.

Situation 1:

Coffee powder grinding is too fine and excessive filling when filling the powder trough, these two actions appear at the same time in the use of mocha pot is more inappropriate. Because it is not a heat exchanger with enough pressure or a household pump, the water vapor pressure generated by the mocha kettle is not enough to penetrate the compact powder layer you have filled, and continuous heating will cause a continuous increase in water vapor. but if too much vapor pressure cannot be eliminated, the mocha pot will easily explode.

Of course, the pressure on the lower seat has been increasing all the time, just like blowing a balloon to blow up a mocha pot and exploding, at this time, the pressure relief valve set up for safety will play a role in draining the excessive pressure and mixing it with the water vapor to improve the method is very simple, do not grind so fine, as long as it is a little finer than the siphon pot; do not over-fill, tap the powder trough to make the coffee powder dense.

Case 2:

No grinding too fine, there is no filling pressure, but it will still exhaust steam from the pressure relief valve. Normal use, but why is there still water vapor discharge? How long have you been using your mocha pot? Perhaps because of your years of use, the rubber o-ring inside the pressure relief valve has lost its elasticity, so although you use it normally, it does not produce too much pressure. However, as the pressure relief valve's ability to accumulate pressure has been reduced due to the aging of the parts, it has been drained out before the pressure can push the water through the powder layer to the upper seat.