The material used in fancy coffee is called milk coffee fancy flower drawing.

The material used in fancy coffee is called milk coffee fancy flower drawing.

Official start: first of all, add the milk foam to the Espresso coffee, and when the milk foam and coffee have been fully mixed, the surface will be thick. That's when it's over. Due to the large size of the foam, you need a larger cup, preferably a Cappuccino cup or mug, and now the formal flower drawing begins. Start from the root of the leaf and shake the wrist holding the flower cup (beating the milk jar) from side to side. The key point is to steadily make the wrist move back and forth horizontally.

Coffee flower drawing is divided into two processes, namely: flower drawing and carving. To pull flowers is to pour milk with milk foam into espresso to make the two kinds of foam unique.

The pattern. However, carving, as the name implies, is to draw a more delicate figure on the surface of the coffee with a coffee needle, extra milk foam or chocolate sauce. Today's coffee carving art can draw the faces of more complex characters or cartoon characters.

First of all, the hand-beaten foam cannot be compared with the steam of the machine at all. The fineness of the steam makes its milk foam very delicate and slippery, and the radiation surface of the steam is wide, so the milk foam will be more uniform and mix better. The hand is mainly squeezed through the small hole of the filter screen, and the milk foam is thicker.

I use my own local method to make milk foam, and it feels good. The appliance is the electric milk beater, 9.9RMB, which is bought by Yijia. Step: add fresh milk to the glass, heat it in the microwave oven for 45 seconds, stir in the milking machine for 1 minute, and the milk foam will become. I use a French press to filter out the 50ml coffee and pour it directly from the top of the foam. I can see that the coffee is gradually mixed with the milk and the white foam rises slowly.

1. Pour the milk into the milk bubble pot, the amount should not exceed 1 stroke 2 of the milk bubble pot, otherwise the milk will overflow due to expansion when making the milk bubble.

two。 Heat the milk to about 60 degrees, but not more than 70 degrees, otherwise the protein structure in the milk will be destroyed. Be careful! The lid and strainer cannot be heated directly. (for example, make ice foam to cool the milk below 5 degrees Celsius, of course, do not overfreeze and let the milk freeze.)

3. Put the lid and the filter on, and quickly twitch the filter to press the air into the milk. when you twitch, you don't need to press to the end, because you want to pump the air into the milk, so you can act on the surface of the milk; you don't need too many times. gently twitch about 30 times.

4. Remove the lid and strainer and scrape off the thick foam with a spoon, leaving dense hot (ice) foam.

Do not put the steam pipe into the milk, because there may be some condensed water in the steam pipe, so let off some steam in the front section and drain the excess water by the way.

Insert the thermometer into the container, then insert the steam pipe obliquely into the milk and turn on the steam switch.

Slowly adjust the position of the steam nozzle to a little bit from the surface of the milk, but never above the liquid level, or the milk will be spilled everywhere. A steady "hiss" will be heard when it is in the right position, otherwise it will be very loud or almost silent.

When the milk foam is sufficient, you can bury the steam pipe a little deeper and let the steam continue to heat the milk. The angle of the steam pipe had better be just enough to make the milk rotate.

The steam switch can be turned off when the diffuse reaches between 60 and 70 degrees.

Wipe the milk attached to the steam pipe with a wet dishcloth and release another steam at the same time to prevent the milk from being difficult to clean after it is dry.