Coffee machine water distribution network how to disassemble and clean, semi-automatic coffee machine cleaning

Coffee machine water distribution network how to disassemble and clean, semi-automatic coffee machine cleaning

One. First turn off the automatic coffee machine, wait for the lights to go off, and then open the cover of the coffee machine.

Two. Take out the dripping tray and coffee residue box and clean them.

Take out the coffee maker and make it clear that the coffee maker can only be taken out when the machine is off. If the machine is turned on, it will damage the coffee maker by force, and do not put the coffee maker into the dishwasher for cleaning.

Please clean the extraction parts with clean water without the use of detergents.

Five. please clean the inside of the machine carefully to remove the coffee residue inside the coffee machine. you can use a wooden or plastic fork for auxiliary cleaning, and you can also use a vacuum cleaner to absorb coffee residue.

Six. after cleaning, when reinstalling, slide on the bracket to install the brown maker and get stuck at the bottom and press the "push" key to the bottom until you hear the stuck sound.

Seven. Reinstall drip tray and coffee residue box.

Eight. close the outer cover of the extraction part and clean it.

1. Use the handle of a spoon against the edge groove of the filter (do not use sharp instruments), change different angles to pry down until the filter falls off. (the same method on the left and right)

2. Put the filter screen, sealing ring and cannon handle into a clean slag tank, add 30 grams of special cleaning powder for coffee machine, soak with 900 ml of boiling water for 20 minutes, then rinse with clean water.

3. After washing the filter screen, sealing ring and gun handle with clean water, put it into a clean slag tank, soak it with boiling water for one night, and install it on the brewing head the next day.

Note: for the installation of the bubble head, put the sealing ring up on the lettered side, put it flat on the filter net, then put it in the handle filter mesh of the bubble head, and finally install the handle straight on the bubble head. (do not tilt, straight and hard to the top, counterclockwise needle rotation handle)

II. External cleaning

1. Remove the filter plate, rinse it with clean water, and then wipe it dry. (do not clean with sharp or hard cleaning utensils)

2. Wipe the whole outside of the coffee machine with a wet towel. Do not leave any stains. (especially the baffle behind the brewing head. Wipe it with a dry towel until there are no water stains.

3. Take two cups of hot water and soak part of the steam rod nozzle.